Saw Blade Alignment on a Table Saw

We advise you to use precise measuring instruments when mounting your saw blade. Mount your saw blade onto the arbor. Adjust the arbor to its maximum height. Verify that the saw blade is parallel to the miter gauge slots. Adjust as needed. This step is necessary to obtain crosscuts with the maximum in quality finish and for setting up the fence for ripping.

The overlap of saw blade teeth over the cutting material must be equal to the height of tungsten tip. The number of teeth cutting simultaneously must be between 2–3.

Pict. No. 5

Pict. No. 6

Here are some useful formulas how to calculate the choice of correct saw blades:

formula      formula     

instructions Legend:
t [mm] – tooth pitch
h [mm] – thickness of the work piece
k [-] – number of teeth in cutting place (2÷3)
z [-] – number of teeth of the saw blade
D [mm] – sawblade diameter

These formulas are valid for cross cutting and cutting of laminated materials.

Tab No. 1 shows the maximum RPM of circular saw blade on basis to the diameter of the blade itself. RPM referring to cutting speed 100 m/sec. These are the maximum recommended RPM by the machine builder. When exceeding this limit, the blade will loose its characteristics and danger implied to user may occur.

Recommended RPM [1/min]
Cutting speed vC [m/sec]

Výše uvedenou tabulku lze výhodně využít ve spojení s Přehledem použití pilových kotoučů s břitovými destičkami SK (PDF 62.1 kB).

formula      formula      formula

vc [m/s] – cutting speed
D [mm] – diameter of saw blade
n [1/min] – recommended RPM
s [m/min] – feed speed
z [-] – number of teeth
sz [mm/zub] – feed speed/tooth
Recommended values of feed/tooth
MaterialFeed speed sZ [mm/tooth]
Soft woods Cutting along the grain0,2 - 0,3
Cutting across the grain0,1 - 0,2
Hard woods0,06 - 0,15
Chipboard0,1 - 0,25
Plywood0,05 - 0,12
Laminated boards0,05 - 0,1
Non-ferrous metals and plastics0,02 - 0,05

© 2006-2020 PILANA Wood s.r.o.,
All rights reserved
Nadrazni 804, 768 24 Hulin, Czech Republic
Tel.: +420 573 328 200, fax: +420 573 328 140, e-mail:
DNV certifications ISO 9001:2000 Topinfo CMS